Guidance Forums / Reginald Rexx / Bug in "Check script for errors"-Guidance指路人

Guidance
指路人
g.yi.org

Guidance Forums / Reginald Rexx / Bug in "Check script for errors"

Home

Software

Upload

回顶部

⇑

Forum List • Thread List • Refresh • New Topic • Search • Previous • Next

1. Bug in "Check script for errors"

#13577

Posted by: Michael S 2012-01-18 16:36:25

I have the following code in my script


bts_wrong_length:

ARG z
y = z * -1
zedsmsg = "Invalid input"
zedlmsg = 'Replacing variables with the BTS string, the variables',
          '"ran out". This probably means you adjusted a length',
          'indicator WITHOUT adjusting the length of the BTS  string', 

IF z < 0 THEN
  zedlmsg = zedlmsg || ' (your BTS string is 'y' byte(s) too long).'
ELSE
  zedlmsg = zedlmsg || ' (your BTS string is missing 'z' byte(s)).'

temp = " (DON'T forget to adjust the value in TRANLÄNGD as well)"
zedlmsg = zedlmsg || temp
rc = wdwsay.rex(zedlmsg, "STOP|")
RAISE FAILURE 2 DESCRIPTION ""
RETURN 0

Note the (invalid) trailing comma before the IF statement. Check script for errors says nothing about this, but when I create an exe and try to run it, I get the attached error message.

Took me a while to track it down, first deleting the script from the project, then adding it, then removing most of the code, then adding procedures one at a time etc etc etc .